Pursuant to section 47(3) of the Maritime Transport Act 1994, the Director of Maritime New Zealand hereby notifies the granting of the following exemptions:
- 6 from Maritime Rule 21.13(1)(b) - Safe Ship Management Systems - Ships which do not proceed beyond restricted limits, fishing ships, and ships of less than 45 metres in length which are not required to comply with section 1 - Entry to and conditions to be met in order for ship to remain in Safe Ship Management System - New Zealand Safe Ship Management Certificate issued by Director
- 1 from Maritime Rule 32.17(1)(c) - Ships Personnel - Qualifications - Officer in charge of a navigational watch of
a foreign going ship route - completion of sea service prescribed in subrule (2)
- 1 from Maritime Rule 32.9(3) - Ships Personnel - Qualifications - Combined skipper/engineer certificates - Local Launch Operator (LLO) - endorse LLO certificate up to 5 additional vessels or areas
- 1 from Maritime Rule 40A.28(1), Table 40A.6 - Design, Construction and Equipment - Passenger Ships which are not SOLAS Ships - Bilge drainage - Bilge pumps - new ship that is decked ship must be provided with the number, capacity, and type of bilge pumps specified in Table 40A.6
- 1 from Maritime Rule 40C.29(2)(e) - Design, Construction and Equipment - Non-passenger ships that are not SOLAS ships - Machinery - Petrol inboard and outboard engines - auxiliary outboard engine of sufficient power for safe return
to port or safe haven
- 1 from Maritime Rule 46.17(1)(b) - Surveys, Certification and Maintenance - Ships which do not proceed beyond restricted limits, fishing ships, and ships of less than 45 metres in length that are not required to comply with section 1 - Inspections - propeller shafts and rudder stocks with water lubricated bearings at intervals not exceeding four years
- 1 from Maritime Rule 47.8(2)(b)(i) - Load lines - Ships of 24 metres or more in length - Owner’s and master’s obligations - ship not proceed on voyage unless surveyed, maintained and marked in accordance with this Section and Load Line Convention